85' YZ250 CLutch Re-assembly

[gb250]

I recently opened my case to replace my shifter shaft and have removed the clutch basket and components. For re-assembly does anyone know how tight to torque the 6 bolts with the springs? Also how is the clutch adjusted at this point for the best results? I am waiting for a manual to come in for this bike I am rebuilding. It's an 85' in good shape, doing a frame up rebuild. Apparently the parts, nor the book are not "high demand" enough for me not to have to wait weeks on end for anything related to it. I was hoping some of you folks could help me out until I get some literature.

Thanks!!

 

[awhtx]

My Clymer manual only goes back to 1988 but it shows 7.2-10 ft/lbs for the year models that it covers. That isn't a whole lot of torque- basically just real snug.

 

[gb250]

Awesome thank you