Home
Basic Dirt Bike How-To's - Video
Dirt Bike How-To's - Video
Living The Moto Life - Video
Bike Tests | Shoot-Outs - Video
Forums
What's new
Latest activity
Log-In
Join
What's new
Menu
Log-In
Join
Navigation
Install the app
Install
More options
Close Menu
Forums
Dirt Bike Discussions By Brand
Honda MX & Off-Road Dirt Bikes
CR250R setup suggestions/help?
Reply to thread
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
[QUOTE="cnielse5, post: 1203667, member: 59291"] I have an 03 cr250. Here is what I have done to mine. I use the low end more and am not that fast. I Have set the sag, and messed with the clickers until it felt comfortable on the bike. I am not far from the stock clicker settings maybe 2 clicks at the most. I did put dunlop 773 tires on it and that helped here in the michigan sand. then I change my tire pressures from 10 to 15psi depending on conditions. As for engine mods I have vforce3 reeds, procircuit works pipe, and pc r304 silencer. I think I am going to go to a platuim 2 pipe (pc version of the gnarly). I went up 2 teeth on the rear to a 50 tooth. as for the jetting I left bike with a 400 main and stock pilot. moved the needle to the 1st position. and My fuel screw is at 1.75 turns. I ride mostly at 600-1200 feet elevation. I also just run Honda HP2 mixed with sunoco 94 octane fuel. I only get detonation at low speeds and when the temperature is below 65 degrees. [/QUOTE]
Verification
Which ocean is California closest to?
Post reply
Forums
Dirt Bike Discussions By Brand
Honda MX & Off-Road Dirt Bikes
CR250R setup suggestions/help?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
Accept
Learn more…
Top
Bottom