Home
Basic Dirt Bike How-To's - Video
Dirt Bike How-To's - Video
Living The Moto Life - Video
Bike Tests | Shoot-Outs - Video
Forums
What's new
Latest activity
Log-In
Join
What's new
Menu
Log-In
Join
Navigation
Install the app
Install
More options
Close Menu
Forums
MX, SX & Off-Road Discussions
Dirt Bike Mods & Maintenance
Cylinder Stud ripped out of cylinder
Reply to thread
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
[QUOTE="RMX250DB, post: 379463, member: 16808"] hello I just did a rebuild on a friends 1994 RM80 and one of the cylinder studs that holds the head in place was pulled out and appears to have stripped out the mounting hole in the cylinder. The stud has aluminum wrapped around all the threads that were in the cylinder which i imagine is what is left of the stud mounting hole. How can i fix this? I was thinking of using a cold weld to hold the stud in the cylinder but ive had bad experiences of cold welds breaking at the worst possible times. Any advice is appreciated. Thanks Tom [/QUOTE]
Verification
Which ocean is California closest to?
Post reply
Forums
MX, SX & Off-Road Discussions
Dirt Bike Mods & Maintenance
Cylinder Stud ripped out of cylinder
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
Accept
Learn more…
Top
Bottom