robwbright
Member
- Apr 8, 2005
- 2,283
- 0
So the 2nd 03 YZ250f I have has a small crack in the carb right around the drain bolt. It appears that the prior owner tightened the drain bolt too tight and cracked the bowl. The crack is about 1/3" long.
I was thinking of putting the bolt in and sealing it with the gas resistant JB Weld. The bowl can always be drained using the big bolt on the bottom of the bowl that allows access to the main jet.
Think it will work?
Reasonable, low cost solution?
I was thinking of putting the bolt in and sealing it with the gas resistant JB Weld. The bowl can always be drained using the big bolt on the bottom of the bowl that allows access to the main jet.
Think it will work?
Reasonable, low cost solution?