Home
Basic Dirt Bike How-To's - Video
Dirt Bike How-To's - Video
Living The Moto Life - Video
Bike Tests | Shoot-Outs - Video
Forums
What's new
Latest activity
Log-In
Join
What's new
Menu
Log-In
Join
Navigation
Install the app
Install
More options
Close Menu
Forums
Dirt Bike Discussions By Brand
Kawasaki MX & Off-Road Dirt Bikes
KX65 plug reading after full engine rebuild - with pics
Reply to thread
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
[QUOTE="Rich Rohrich, post: 1459048, member: 16241"] If it feels sharp in the midrange without hesitation it sounds like you have the needle jetting pre spot on . Double check the main on a short WOT run with a clean plug and you should be good to go. Don't worry about a no load bog on the stand, it doesn't mean much if the bike responds properly on the track. I would run the 9 series plug based on the pics you posted. If the plug is getting too hot you'll see signs of blistering on the nose and glazing of the ceramic where it looks like glass. It's hard for most riders to push a bike hard enough on an MX track to need a cold plug like a 10. That's more for running in sand all day or deep mud where the load is high at all points all day. [/QUOTE]
Verification
Which ocean is California closest to?
Post reply
Forums
Dirt Bike Discussions By Brand
Kawasaki MX & Off-Road Dirt Bikes
KX65 plug reading after full engine rebuild - with pics
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
Accept
Learn more…
Top
Bottom