wheel bearings: 99 CR250

[SlowMo'e]

Hello everyone. I'm looking for some advice on removing my rear wheel bearings. I tried tapping the first one out from the opposite side of the hub, but there's not enough surface exposed to get a good "grip" -- my drift just slips off. If anyone can offer some advice or reccommend a good(best?) sevice manaul I would be grateful.

 

[darringer]

Make sure the bearing retainer is removed. They have a tendency to be very hard to remove. Heat the hub with a propane torch. The bearings should come out with a little persuasion.