Home
Basic Dirt Bike How-To's - Video
Dirt Bike How-To's - Video
Living The Moto Life - Video
Bike Tests | Shoot-Outs - Video
Forums
What's new
Latest activity
Log-In
Join
What's new
Menu
Log-In
Join
Navigation
Install the app
Install
More options
Close Menu
Forums
Dirt Bike Discussions By Brand
Honda MX & Off-Road Dirt Bikes
1998 CR250 hub same as 2000 CR250 hub? Swap question.
Reply to thread
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
[QUOTE="winchcable, post: 956387, member: 49186"] Hello all, I have a 1998 CR250, I bought a set of wheels that were supposed to be from a 1999 CR250. When I went to switch the wheels, I noticed the hub on the rear had the larger hole for the 2000+ axle. I looked at both hubs and they look the same, both have the same numbers on the disc side of the hub (I can't remember what they are right now). I didn't take any measurements though. My question is this: If I take out the bearings from the new wheel, can I put a fresh set of 1998 bearings in their place? The only difference that I saw (remember, I didn't look too hard) was that the diameter for the axle was larger. I didn't pull any bearings to see if all I would have to do is switch internals between the two wheels. Thanks. [/QUOTE]
Verification
Which ocean is California closest to?
Post reply
Forums
Dirt Bike Discussions By Brand
Honda MX & Off-Road Dirt Bikes
1998 CR250 hub same as 2000 CR250 hub? Swap question.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
Accept
Learn more…
Top
Bottom