Home
Basic Dirt Bike How-To's - Video
Dirt Bike How-To's - Video
Living The Moto Life - Video
Bike Tests | Shoot-Outs - Video
Forums
What's new
Latest activity
Log-In
Join
What's new
Menu
Log-In
Join
Navigation
Install the app
Install
More options
Close Menu
Forums
Dirt Bike Discussions By Brand
Honda MX & Off-Road Dirt Bikes
CR250 Power Valve Cables
Reply to thread
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
[QUOTE="+30, post: 962957, member: 62658"] [b]powervlv maint[/b] check out [url]http://www.motocrossactionmag.com/readridingtips.asp?id=471[/url] I still cuss often at these cables when doing a top end. sorry dead link 1 turn actuator ccw until stops 2 push left side cable to left. if you can push it to the point where it touches the cyl its too loose. 3 10mm wrench on lock nut 4. 8mm wrench on left side cable unitl tiny bit of slack do not make it taut. 5. tighten the nut replace cover. "the cr's power vlv servo has no way to take up slack in the cables the power vavle module pulls the same amount of cable wether the cables are properly tightened or slack...the servo moto will spend some of its precious rotation removing slack...the flapper valve will not have moved all the way up in the exhaust port." [/QUOTE]
Verification
Which ocean is California closest to?
Post reply
Forums
Dirt Bike Discussions By Brand
Honda MX & Off-Road Dirt Bikes
CR250 Power Valve Cables
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
Accept
Learn more…
Top
Bottom