Home
Basic Dirt Bike How-To's - Video
Dirt Bike How-To's - Video
Living The Moto Life - Video
Bike Tests | Shoot-Outs - Video
Forums
What's new
Latest activity
Log-In
Join
What's new
Menu
Log-In
Join
Navigation
Install the app
Install
More options
Close Menu
Forums
Dirt Bike Discussions By Brand
KTM MX & Off-Road Dirt Bikes
PVL ignition help needed!
Reply to thread
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
[QUOTE="nuttyman, post: 633981, member: 44942"] I had to replace the CDI on my ignition (94 RM250) system recently. The stock module was about $100 less thasn a complete PVL system, so I went with the PVL. Problem is, the documentation that came with the PVL does not say where to set the rotor-how many deg. BTDC to set it. I get 120 psi with exhaust valve open & ~ 135 psi with it closed. I run 91 octane pump gas but also have 110 octane race gas readily available. I made a degree wheel with and have set the rotor to ~ 25 deg. BTDC. Please, anyone with any experience with these ignitions help me! Where do I set the rotor, and the stator? I appreciate any help given. nutty [/QUOTE]
Verification
Which ocean is California closest to?
Post reply
Forums
Dirt Bike Discussions By Brand
KTM MX & Off-Road Dirt Bikes
PVL ignition help needed!
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
Accept
Learn more…
Top
Bottom