Home
Basic Dirt Bike How-To's - Video
Dirt Bike How-To's - Video
Living The Moto Life - Video
Bike Tests | Shoot-Outs - Video
Forums
What's new
Latest activity
Log-In
Join
What's new
Menu
Log-In
Join
Navigation
Install the app
Install
More options
Close Menu
Forums
Dirt Bike Discussions By Brand
Honda MX & Off-Road Dirt Bikes
Reinstalling rear wheel 01 CR250
Reply to thread
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
[QUOTE="parkerCR, post: 900908, member: 25783"] I am in the process of installing the rear wheel on an 01 CR250. I cannot even with two people get the right side to line up for the axle to go through. I clip the brake assembly to the backside of the swingarm by slifding it into the grooves. No matter how much I lift pull or push I can't get the rubber grommet on the right side to line up with the hole that drops down from the brake assembly. The hole connected to the brake assembly lines up with the chain adjuster hole but the grommet always falls about an 3/8" below and to the outside of lining up. What am I doing wrong? Spent 2 hours trying to get it to line up with another person. Thanks :bang: [/QUOTE]
Verification
Which ocean is California closest to?
Post reply
Forums
Dirt Bike Discussions By Brand
Honda MX & Off-Road Dirt Bikes
Reinstalling rear wheel 01 CR250
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
Accept
Learn more…
Top
Bottom