Home
Basic Dirt Bike How-To's - Video
Dirt Bike How-To's - Video
Living The Moto Life - Video
Bike Tests | Shoot-Outs - Video
Forums
What's new
Latest activity
Log-In
Join
What's new
Menu
Log-In
Join
Navigation
Install the app
Install
More options
Close Menu
Forums
Dirt Bike Discussions By Brand
Husqvarna MX & Off-Road Dirt Bikes
Swingarm Spindle Seized - HELP
Reply to thread
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
[QUOTE="JasonJ, post: 780007, member: 23758"] It took 3 guys to get the one out of my old IT 250. One guy trying to spin the axle shaft with an impact gun, one guy smacking the other side with sledge hammer, and one guy heating with an Oxey Asettalen tourch. When it finally started to turn and move, we switched from a sledge to an air hammer to start pounding it out while it was spinning. The alluminum in the swing arm wicks to much heat to use anyting but a serious tourch in most cases. Other than that, we would have had to rig the bike ino a hydrolic press to push it out. BTW: I had the nut on the end to chace the threads but we hit is so hard, I had to gring the end of the axle down just to get the nut off :eek: . My swing arm bearings were so beat I was pumping grease into a fitting I tapped in every ride. [/QUOTE]
Verification
Which ocean is California closest to?
Post reply
Forums
Dirt Bike Discussions By Brand
Husqvarna MX & Off-Road Dirt Bikes
Swingarm Spindle Seized - HELP
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
Accept
Learn more…
Top
Bottom