Well back to work on my bike. This time the crank bearings broke and cause the rod to jam inside the case breaking the cylinder head and other stuff. Bad Luck! I try to take care of my bike and this happens. I notice that the case has a crack inside were the oil is poured in. The crack is large. But the outside seal is still good. The issue is going to be that the oil will go straight into the crank sections without going down into the bottom of the where the holes are that feed the oil to other sections. The question I have is should I buy a new right side case or just us this one. I don’t see why oil going straight to the crank case is an issue. Only other thing is that the oil needs to be pushed up the cams but I think this is done by the oil pump. What do you guys think? Cost for a new one is $350. I already need new crank, piston, cylinder, gaskets, other stuff. how to we post pictures?