Hey guys, I kind of put this project on the back burner as my health hasn't been the greatest this spring.... My CR 250 rebuild is complete, other then now it has no spark at all. When I got it running after the rebuild it had "decent" spark except the RC electronic powervalve was not working, suspected the new electrosport stator as the issue as it ran fine before I ruined the oem one. Got a replacement stator and cleaned up the contacts on the ecm behind the front number plate (they were clean to begin with) and also noticed there was some rust on the actually coil pack where bolt's and grounds to the frame. I cleaned the contact path up really good, thought for sure that was my problem but still no spark at all. My guess is that at this point the coil is probably bad? I'm just hoping the ECM brain isn't dead... Any input? I really want to get this bike running bad!