OK so I rebuilt my 03 kx125 and had some issues with heavy azz smoke (was the float hight) now I am wondering about the jet needle,, mine has a very sharp tapper as it drops diameter 9 mm from the end and stays very thin till the end....
I have never seen one like this and I think it may be worn down....
and it kinda reflects my power problems...it's kinda sputtery/bogging and nothing untill I get it wound out to the top..then sometimes it will hit a power surge.
I am looking to replace the jet needle and need help picking one that will work good w/ my base and head mod from Eric Gorr it was shaved at the bottom for more low end.
any other jetting suggestions welcome.
80-95 degrees
700- 2500ft
everything is stock now..40/420/ 2nd clip from top
I have never seen one like this and I think it may be worn down....
and it kinda reflects my power problems...it's kinda sputtery/bogging and nothing untill I get it wound out to the top..then sometimes it will hit a power surge.
I am looking to replace the jet needle and need help picking one that will work good w/ my base and head mod from Eric Gorr it was shaved at the bottom for more low end.
any other jetting suggestions welcome.
80-95 degrees
700- 2500ft
everything is stock now..40/420/ 2nd clip from top