HONDA Cr 125 1997 coil resistence.values....HELP
HI
I dont have the owner´s manual of this bike, so i need the coil resistence values, because my bike don´t start and want to verify the stator.....
My bike was stoped 2 years, so start ok over 20 minutes, and later stoped and never start again....
The spark is so weak, that i supouse that the wet sand and dust inside the ignition room and inner rotor flywheel lmake the coils performance down..........and the coils in the stator have a lot clearence and maybe disaligment the magnetic waves ...
Anyway.....my tester show me:
Ignition coil :
primary 1 Ohm
secondary 18 K Ohms (with spark plug cap) and 13 without
Stator:
Ignition pulse 240 Ohms
Exiter coil 65 Ohms.....................possible failure
I think that the normal value is 180 ohms aprox.
I dont have the Peak voltage adaptor module in my tester, so i can´t measure the peak voltage ...............
Help me please, i bealive in the knowledge of the motocross community.....
Thanks
HI
I dont have the owner´s manual of this bike, so i need the coil resistence values, because my bike don´t start and want to verify the stator.....
My bike was stoped 2 years, so start ok over 20 minutes, and later stoped and never start again....
The spark is so weak, that i supouse that the wet sand and dust inside the ignition room and inner rotor flywheel lmake the coils performance down..........and the coils in the stator have a lot clearence and maybe disaligment the magnetic waves ...
Anyway.....my tester show me:
Ignition coil :
primary 1 Ohm
secondary 18 K Ohms (with spark plug cap) and 13 without
Stator:
Ignition pulse 240 Ohms
Exiter coil 65 Ohms.....................possible failure
I think that the normal value is 180 ohms aprox.
I dont have the Peak voltage adaptor module in my tester, so i can´t measure the peak voltage ...............
Help me please, i bealive in the knowledge of the motocross community.....
Thanks