Home
Basic Dirt Bike How-To's - Video
Dirt Bike How-To's - Video
Living The Moto Life - Video
Bike Tests | Shoot-Outs - Video
Forums
What's new
Latest activity
Log-In
Join
What's new
Menu
Log-In
Join
Navigation
Install the app
Install
More options
Close Menu
Forums
Dirt Bike Discussions By Brand
Canadian Daves JustKDX
Kickstand Bolt size
Reply to thread
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
[QUOTE="mitchw, post: 961721, member: 38682"] The size of the (2) flanged bolts used to attach the kick-stand mounting tab to the swingarm are 12X25 (12mm dia. X 25mm length) they have a fine thread pitch of 1.25mm (I think--going from memory here). The flanged bolt needed to attach the kick-stand to the mounting tab is 10X35. I too had to replace the kick-stand bolt with an aftermarket one. Just watch for the length of the bearing surface, that non-threated area below the head of the bolt. You want the two tabs of the kick-stand to ride on the bearing surface and not the bolt threads themselves. I wound up buying a longer bolt than the stock 10X35 to get the longer bearing section. I then just cut the excess off with the old hacksaw. It's the custom bearing shaft length that makes the OEM bolt so expensive. Hope this helps. :cool: P.S. On the kick-stand bolt, I used a flanged nylock nut and haven't had any problems with it loosening up. [/QUOTE]
Verification
Which ocean is California closest to?
Post reply
Forums
Dirt Bike Discussions By Brand
Canadian Daves JustKDX
Kickstand Bolt size
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
Accept
Learn more…
Top
Bottom